0011 トランセル〔ポケモン折り紙〕トランセルの作り方/みるかなた

Metapod

1 Fold the bottom corner to meet the top corner.
2 Fold at an angle that is one-third of the angle of the left corner.
(150mm * tan15° ≒ 40mm, approximately 40mm from the top)
3 Since the folding distance is long and there are no corners or edges to align, it is easy to distort, so use a ruler to guide the folding.
{Flip}
4 Fold in the same position as the paper behind.
5 Open.
{Flip}
6 Rotate 90 degrees and fold the bottom peak up.
7 Make a crease and return.
8
{Flip}
9 Fold at a right angle to the edge in the center of the bottom left edge.

11 Fold the bottom right edge at a right angle to the edge in the center.
12 Hold the ▲ part with your fingers and fold gently from the left and right.
13 Fold naturally along the creases to create a basic square, forming the shape of 15.
14
15 Fold the top left and right edges of the paper in front, in line with the crease in the center.
16 Turn back.
17 Fold the bottom peak at the point where the crease from 16 intersects with the bottom left and right edges.
18 Make a crease and turn back.
19 Fold the paper in front downwards along the crease you just made.
20 Open the right arrow with the index finger of your right hand to form the shape of 21.
21 Open the left arrow with the index finger of your left hand to form the shape of 22.
22

{Enlarge image}
23 Change the top and bottom positions. Fold the bottom part of the paper in the middle on the right side and fold it between the two pieces of paper. Specifically, fold it as shown in Figure 24 below.
24 While opening the arrow with the index finger of your right hand, fold the bottom paper inward.
25
{Flip it over}
26 While opening the paper in front using the arrow, fold it into the shape of 27.
27 On the left side only, fold the part sticking out towards you.
28 Fold the left side about 30 mm above the bottom edge of the left side.
29 Fold the right side about 10 to 15 mm above the bottom edge of the right side.
30 While opening the arrow, pull the paper in front to the right to form the shape of 31.

31 Fold the right part to the left.
32 Fold the bottom piece of paper up. Since the paper is thick, use a ruler to fold it firmly.
33 Use a ruler to fold it down at a slight angle.
34 Repeat steps 32 and 33, folding twice more.
35
{Flip}
36 Tilt the paper about 30 degrees.
37 The Metapod is finished.